Where else would a boy from Birmingham start his working life but in an iron foundry?
It’s fifty years this month since I started my first full-time job at Rood End Foundry in Oldbury in the Black Country.
Iron founding is hot, noisy, dirty and dangerous. And the worst job in a
foundry is repairing the lining of the furnace where the iron is
melted.
Every morning at 8 o’clock you climb up inside the cupola – that’s the furnace – where it had been 1500degC the day before.
The cupola is a vertical steel cylinder ten metres tall that squats a
metre off the ground on four short steel pillars. It is lined with fire
bricks 20–30 cm thick, leaving a hollow shaft up the middle like a well
50 centimetres across. You have to crawl in from the bottom and climb
two metres up into that well to repair the lining.
There is
barely enough room for a big man to fit into the well. It’s difficult to
bend your knees to climb the ladder. You can’t stick your elbows out to
work until the shaft widens slightly in the melting zone two metres up.
The firebrick lining holds the heat from the previous day’s melt so
it’s like being in an oven, and that heat causes a tremendous up-draft
carrying dust, grit and fumes that make it hard to breathe.
First
you chisel off the lumps of solidified slag from the walls, then you
plaster the eroded spots with ganister – a special kind of fire clay.
Your buddy outside has a wheel-barrow full of the stuff. He forms a big
dollop into a ball and shoves it up the well as far he can reach with
you inside – hopefully near your crotch where you can just reach it
without bending - you can’t bend, there’s not enough room. Then you work
the ball of ganister up your body until it reaches the slightly wider
melting zone level with your chest. Now you can get your arms up and
plaster the walls of the well. Then you grab another dollop.
The
black and white photo gives you a bit of an idea. To take it, I crawled
in through the charging hole one floor up and pointed the camera down
the shaft of the furnace. You can see the top of my offsider Sam’s head
as he patches the lining. Earlier, that was me down there.
I’ve
kept that photo near me through every job I’ve ever had since then; all
through teaching, as a speechwriter, policy adviser, public servant,
consultant and writer. It’s next to my computer now as I type. Whenever
work threatened to get a bit overwhelming or colleagues were being
awkward, I would look at that photo and remember that things could be a
whole lot worse, and some people have to put up with much more difficult
situations throughout their whole working life.
In other photos,
you can see Big Joe Winston standing at the bottom of the cupola. He is
holding a steel rod (a “bott stick”) to chip out the plug that releases
the flow of molten metal. He offered to teach me how to do it; he’d
been doing it for years. But I passed on that one – make a mistake and
people can get killed.
Below, round the side of the cupola, slag is
blowing off through a vent. On the foundry floor, molten iron is flowing
from a drum ladle into a floor mould. Munsih Ram is using a spoon ladle
to pour iron into moulding boxes while his workmate uses a larger
two-handed ladle.
